Test fixture adapter for Tektronix curve tracers. Fits Tek 576, Tek 577 test fixtures, possibly others.
| Item | Qty | Source |
|---|---|---|
| Prototype Board, 5x7mm, 0.1 in. hole pitch | 1 | |
| 4 mm RC-style banana plugs | 3 | |
| 6mm silicone rubber feet | 2 | |
| TO-252 burn-in adapter | 1 | |
| M3x8mm button head socket screws | 4 | |
| M3 nuts | 4 |
Drill Press*, 3/16" drill bit*, 3D printer, any rigid filament (PETG, PLA, ABS, etc.), soldering iron, hookup wire.
Printed part models are in 'STL/' folder. Please also check the 'img/' folder for assembly pictures.
-
Print bottom, middle, and top pieces, as well as two jigs. Printing parameters: 0.6mm or smaller nozzle, 0.3mm or lower layer height.
-
Using the drill jig find holes that can be used as pilots for 3mm screws on the prototype board, mark them, remove the jig, then drill 3mm holes where marked.
-
Screw the drill jig to the board, drill 3/16" holes for the banana plugs.
-
Cut the excess material. A drill jig can be used to make the clean edge.
-
Insert banana plugs as shown. Check the height protruding from the other side, should be 1mm*. A leveling jig can be used.
-
Insert* and solder TO252 test socket as shown. Connect the socket pins to the banana plugs.
-
Assemble 3 printed pieces and PCB as shown.
